Angled brick supports
I finished bricking the flat surfaces of the middle section and then had to address the row of angled bricks. The easiest way I figured I could manage the illusion of three-dimensional bricks stacked on an angle was with strip wood covered with egg carton on the exposed edge. I used 1/4in strip wood cut into pieces roughly 5/16in tall. I glued these individual blocks into place with the corner pointing outward. I set them in just a bit to leave room for the egg carton and to offset them from the face of the brick...just in case I didn't get them lined up perfectly, it wouldn't show as much. Once these dry, I'll add the egg carton to the exposed portions.
Recommended Comments
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.