floors & doors
here are some of the 6" X 1/8" "floorboards I cut from the veneer; it is real red oak! I made two exterior crossbuck doors with the intention of pin-hinging them. Two months and countless efforts later I'm giving up & going to make new crossbuck doors and hinge them with chamois strips in my usual way.
To make these particular doors I had some very small craft sticks not quite 3/4 the size of the lolly-stick kind. I traced an outline of the door opening and lay the sticks side-by-side to see how many I'd need for the width. Then I lay one along the edge of my tracing and marked where the top & bottom came and cut off the ends at those marks. I cut four more the width of the door and used masking tape to see how they looked, with the last four flush with the top & bottom of each door; and I took two last sticks and lay them across corner to corner from top to bottom and marked each side where they crossed the cross-pieces and cut them. Then I stained them and, when they were dry, glued them together. Then I marked where I wanted to drill the holes for the pins in the top & bottom edges of the doors, measuring meticulously. Then I matched those measurements precisely on the floor and top of the doorway whilst the house was in dry-fit, and drilled them before assembling with glue. And guess what, nothing will fit!
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.