the hinge
This is the finished hinge. cut a small groove wide enough for the screw eye to fit in. Drill a hole just big enough for your pin to go in and deep enough to go through the eye and into the other side of the groove. Place the screw eye on the groove and push the pin into the hole. Trim off excess length on the pin so it is flush with the door. To install to the cabinet drill two holes large enough for the threaded end of the screw eye into. Use a dot of glue in each hole and press the threaded ends in the holes.
- 1
Recommended Comments
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.