Turntable

How are you attaching it to the house? I have the same apparatus and I did not come with instructions

HI! First; I watched this video:

I'm not actually attaching it to the house; I have a large board that I'm using for a base (which is an issue in itself, since I forgot that the board's so long that it BENDS since there's only a little support int the middle...) and that's what i attached it to. First, oil up the bearings!!! A lot!!! (I used my husband's hair clipper oil, lol.) Next, I centered the lazy susan on the small base piece, and marked the holes. Then I centered the lazy susan on the large board (bottom side) and marked holes. Then (and this is the part I had trouble with until I watched that video) I drilled an access hole in the small base piece. Make it large enough to get a screwdriver and screw into. Attach the lazy susan to the base piece with your screws, then turn the whole thing over and line up the holes with the marks you made in the "table" piece, using the access hole to see what your doing. (Line up one, then spin to the next, etc... then give them all one last check when you think they're lined up.) Then use the access hole to install the screws. (Basically, going all the way from the base piece through to the underside of the table piece.) Once you're done, give it a spin!

Hope that helps!