Setting the veneer around the leaf 1 frame
I taped the outer walnut boards and the center vein onto the frame support to mark where the support beams should end under the surface boards. I cut the frame using the scroll saw, cutting in slightly to allow room for a veneer finish around the outside.
The local Home Depot had only the iron-on pre-glued veneer strips, and I didn't want to wait to order online, so I used birch veneer. I had some leftover from previous projects. I cut a strip 1/4" wide and glued it around the outer edge. It doesn't hit every point, but that's fine with me. It creates a natural smooth finish around the outer edge and hides the framework (unless viewed from underneath).
- 1
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.