Dry Fit
I did a dry fit of the main trailer pieces using masking tape. This kit uses very few tabs & slots; most pieces just butt together at the edges. I think I've worked out the ways everything will overlap when the time comes to use glue. Most of the pieces fit together pretty well. I think the most trouble will be where the curved veneer sections meet the upper roof. From researching this forum's older posts on this kit, I hope to be prepared to control the warping with the veneer sections.
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.