Recently Browsing 0 members
No registered users viewing this page.
Help! I started my first dollhouse and FINALLY got to a finishing point after about a year and a half. There are still a few minor things that need done but it’s finished enough for now (I needed to finish it by Xmas for my daughter). I have made dozens of little 1:24 models in the past and am a little knowledgable in electrical (aircraft electrician over a decade ago) but have since become rusty in the topic. I opted to install 6, small LED lights into the dollhouse, connected by a series of 9v batteries. Since my other smaller models have included similar setups with the LEDs and batteries, I didn’t think this would be an impossible task. I have ordered 9V lights and hardwired them into the house, connecting them in series to 6, 9v battery housing and a switch. It had seemed a bit of overkill to me, since the smaller models often used a single AA battery for often up to 4-5 bright lights. Except, it was very dim (which I don’t mind too much, as it’s more for effect anyway) and lasted maybe 30 minutes before dying. I’m lost now on what to do. I would have to completely cut into the house and moulding to replace the wiring. Thoughts? Did I completely mess this up? Help!! I will try to post pictures of the setup.
Good day! This is my first post in the forum - go easy on me!
I'm an absolute beginner, currently building a 1:18 scale recreation of a local heritage house that was torn down 4 years ago. So far things are going well, but like MANY miniature newbies, I am absolutely confused by the wiring aspect of the build.
I have done as much internet research and forum reading as I can, but I'm still not sure if I'm doing the correct thing.
So, here it goes. These are my supplies:
Cir-Kit Basic Wiring Kit
Transformer (FIFODR® 12V 5A 60W DC Power Supply Adapter(Input 110V-220V,Output 12 Volt 5 Amp 60 Watt) DC Converter LED Driver Lighting Transformer for 12V 5A Flexible/Rigid 5050/3528/2835/5630/5730 LED Tape Strip Light FD-ADP60W)
Lights (Pre Wired DC 9-12V 3mm Water Clear LED Diodes White Light)
First question: Will the lights I purchased work with the tape wire kit?
Second question: I will obviously need to purchase extension wire for the lights - what type of wire am I looking for?
Third question: My house is mostly foam core on the inside, but the outside walls will be wood. I'm thinking of only installing the tape wire to the wood outer structure and laying/hiding the wire through the house, linking to the outside tape wire (does that make sense?). Will that work?
Thanks in advance for any help you can provide!!