Fireplace with firebox and Phoenix Models hob grate
Before I could truly get to work on the parlor floor, I needed to finish up the parlor fireplace. In order to know where to start the firebox, I had to make the hearth. I cut a piece of cardboard a little thicker than the parlor floor marquetry border. More on that later.
Next up was building the firebox using my standard method. The firebox sits partially inside the chimney through a hole in the side wall. This will be finished with egg carton brick.
I'm using a Phoenix Models firegrate and resin coal fire, so the box didn't need to be very deep. The resin coal wire will exit out the back. I might end up installing a flickering unit for the fireplace, so I'll determine the final wiring pattern later.
Recommended Comments
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.