Backplate for light
Before I could install the actual 12V lights and the mock knob and tube system, I needed to address the fixtures. They seem to have rather delicate connections for the backside wiring. Those wires would prevent them from sitting flush on the cross beams besides.
So, I cut thin plaques from 3/8" x 1/16" strip wood to mount them. The fixtures are glued to the plaques, leaving room for the wiring to exit the back while protecting the delicate connections.
Copyright
© brae oktober
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.